ABB ACS880 Firmware Manual page 182

182 Parameters
No. Name/Value
STOPPING
EM_STOP_ACTIVE An emergency stop command signal is active, or the drive is
09.03 Actual tension ctrl
mode
Open loop
Tension torque trim
Tension speed trim
Dancer speed trim
Line speed control
Threading
Torque memory
Not active
09.11 Actual diameter
0.0...32767.0 mm
09.12 Actual diameter %
0.00...100.00%
09.13 Diameter ratio
0.0000... 1.00000
09.14 Diameter ratio
inversed
1.00... 100.00
09.21 Estimated length
0.0... 100000.0 m
09.25 Roll estimated
weight
0.0... 32767.0 kg
09.31 Actual tension
0.0...32767.0 N
09.36 Torque trim
-100.00... 100.00%
Description
Drive is stopping.
stopping after receiving an emergency stop command.
Displays the active tension control mode.
Open loop tension control is active.
Tension control with torque trim is active.
Tension control with speed trim is active.
Dancer control with speed trim is active.
Line speed control is active.
Threading is active.
Torque memory is active.
None of the tension control modes are active.
Displays the actual filtered diameter.
Actual filtered diameter.
Displays the actual diameter in percent of the full roll.
Actual diameter in percent of the full roll.
Displays ratio of the core to the actual diameter.
Ratio of core to actual diameter.
Displays the diameter ratio inversed.
Inversed ratio of the actual diameter to the core.
Displays total length of the material wound on the roll
estimated from the actual diameter with regard to the
defined material properties (in parameter group
Application setup).
Estimated length.
Displays total weight of the material wound on the roll
estimated from the actual diameter with regard to the
defined material properties (in parameter group
Application setup).
Estimated roll weight.
Displays the actual tension based on the unit selected in
parameter 77.91 Tension measure
Actual tension.
Displays torque reference correction term used in Torque-
trim tension control mode (parameter
mode = Tension torque trim). The reference sign is chosen
automatically based on settings in parameters
Winding mode and 74.06 Motor
Torque trim from the tension control.
74
74
selection.
77.02 Tension control
74.05
direction.
Def/FbEq16
8
9
Open loop
0
1
2
3
4
8
9
10
0.0 mm
10 = 1 mm
0.00%
100 = 1%
0.0000
10000 = 1
0.00
100 = 1
0.0 m
10 = 1 m
0.0 kg
10 = 1 kg
0.0 N
10 = 1 N
0.00%
100 = 1%