ABB ACS880 Firmware Manual page 154

154 Parameters
Group
45 Energy efficiency
46 Monitoring/scaling settings
47 Data storage
49 Panel port communication
50 Fieldbus adapter (FBA)
51 FBA A settings
52 FBA A data in
53 FBA A data out
54 FBA B settings
55 FBA B data in
56 FBA B data out
58 Embedded fieldbus
60 DDCS communication
61 D2D and DDCS transmit
data
62 D2D and DDCS receive
data
74 Application setup
75 Winder speed settings
76 Diameter calculation
77 Tension/Dancer control
78 Winder PID controller
79 Mechanical losses
compensation
80 Turreting assistance
81 Winder safety
82 Virtual Roll
90 Feedback selection
91 Encoder module settings
92 Encoder 1 configuration
93 Encoder 2 configuration
95 HW configuration
96 System
Contents
Settings for the energy saving calculators.
Speed supervision settings; actual signal filtering; general scaling
settings.
Data storage parameters that can be written to and read from using
other parameters' source and target settings.
Communication settings for the control panel port on the drive.
Fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
Fieldbus adapter B configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
Configuration of the embedded fieldbus (EFB) interface.
DDCS communication configuration.
Defines the data sent to the DDCS link.
Mapping of data received through the DDCS link.
Winder control and setup.
Ramping time adjustments and winder-related speed reference
adaptation setup.
Diameter calculation control and setup.
Tension control and setup.
PID controller settings.
Friction compensation control and setup.
Torque memory control and setup.
Settings for web loss.
Settings for the virtual roll function.
Motor and load feedback configuration.
Configuration of encoder interface modules.
Settings for encoder 1.
Settings for encoder 2.
Various hardware-related settings.
Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection; data logger triggering; parameter checksum calculation;
user lock.
Page
362
365
369
371
374
382
383
384
384
385
386
386
394
405
409
415
419
425
429
436
442
446
449
453
456
465
468
474
476
481