ABB ACS880 Firmware Manual page 169

No. Name/Value
06.11 Main status word
0000h...FFFFh
06.16 Drive status word 1
Bit Name
0 Enabled
1 Inhibited
2 DC charged 1 = DC circuit has been charged
3 Ready to
start
4 Following
reference
5 Started
6 Modulating
7 Limiting
8 Local control 1 = Drive is in local control
9 Network ctrl 1 = Drive is in
10 Ext1 active
11 Ext2 active
12 Reserved
13 Start request 1 = Start requested
14...15 Reserved
0000h...FFFFh
Description
Main status word of the drive.
The bit assignments are described on page 638. The related
control word and state diagram are presented on pages
and 639 respectively.
This parameter is read-only.
Main status word.
Drive status word 1.
This parameter is read-only.
Description
1 = Both run enable (see par. 20.12) and start enable (20.19) signals are
present. Note: This bit is not affected by the presence of a fault.
1 = Start inhibited. See parameters
inhibiting signal.
1 = Drive is ready to receive a start command
1 = Drive is ready to follow given reference
1 = Drive has been started
1 = Drive is modulating (output stage is being controlled)
1 = Any operating limit (speed, torque, etc.) is active
network control
1 = Control location EXT1 active
1 = Control location EXT2 active
Drive status word 1.
Parameters 169
06.18 and 06.25 for the source of the
(see page 17)
Def/FbEq16
-
637
1 = 1
-
1 = 1