Application Setup - ABB ACS880 Firmware Manual

No. Name/Value
62.102 Data set 10 data 2
value
0...65535
62.103 Data set 10 data 3
value
0...65535
62.104 Data set 12 data 1
value
0...65535
... ...
62.124 Data set 24 data 3
value
0...65535
74

74 Application setup

74.05 Winding mode
Winder
Unwinder
Other
74.06 Motor direction
Positive
Negative
Other
74.11 Gear ratio 1
0.010...32767.000
74.12 Gear ratio 2
0.010...32767.000
Description
Displays (in integer format) the data received from the
external controller as word 2 of data set 10.
A target for this data can be selected by parameter
Data set 10 data 2 selection.
a source by another parameter.
Data received as word 2 of data set 10.
Displays (in integer format) the data received from the
external controller as word 3 of data set 10.
A target for this data can be selected by parameter
Data set 10 data 3 selection.
a source by another parameter.
Data received as word 3 of data set 10.
Displays (in integer format) the data received from the
external controller as word 1 of data set 12.
A target for this data can be selected by parameter
Data set 12 data 1 selection.
a source by another parameter.
Data received as word 1 of data set 12.
...
Displays (in integer format) the data received from the
external controller as word 3 of data set 24.
A target for this data can be selected by parameter
Data set 24 data 3 selection.
a source by another parameter.
Data received as word 3 of data set 24.
Winder control and setup.
Selects whether the driven machine acts as a winder or
unwinder.
Material is wound to the core.
Material is unwound from the roll.
Source selection (see Terms and abbreviations
152).
Selects the direction of the motor rotation.
Motor rotates clockwise. The speed reference goes positive.
Motor rotates counterclockwise. The speed reference goes
negative.
Source selection (see Terms and abbreviations
152).
Defines the gear coefficient value 1 between the motor and
driven load.
Example: You can set the value as 2 if the motor rotates two
rounds for one round of spindle rotation (2:1).
Gear coefficient value.
Defines the gear coefficient value 2 between the motor and
driven load.
Example: You can set the value as 2 if the motor rotates two
rounds for one round of spindle rotation (2:1).
Gear coefficient value.
62.52
The value can also be used as
62.53
The value can also be used as
62.54
The value can also be used as
62.74
The value can also be used as
on page
on page
Parameters 415
Def/FbEq16
0
0
0
...
0
Winder
0
1
-
Positive
0
1
-
1.000
1000 = 1
1.000
1000 = 1