Turreting Assistance - ABB ACS880 Firmware Manual

446 Parameters
No. Name/Value
83

80 Turreting assistance

80.01 Take torque sample
80.02 Torque memory enable
80.01 Take torque sample
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other
80.02 Torque memory
enable
Not selected
Selected
DI1
DI2
DI3
DI4
Description
Torque memory control and setup.
See section Torque memory
Start of index
Sample torque for torque memory
Torque memory enabled
Selects the source for the trigger command to capture a
torque sample.
Torque memory sampling not activated.
Torque memory sampling activated.
Digital input DI1
Digital input DI2
Digital input DI3
Digital input DI4
Digital input DI5
Digital input DI6
Digital input/output DIO1
Digital input/output DIO2
Source selection (see
page 152).
Activates/deactivates the torque memory usage (torque
memory used as the torque reference), or selects the source
for the activation signal.
Torque memory usage not activated.
Torque memory usage activated.
Digital input DI1
Digital input DI2
Digital input DI3
Digital input DI4
on page 59.
Finishing roll isolated
80.12 Boost ON-
delay
(10.02 DI delayed status, bit 0).
(10.02 DI delayed status, bit 1).
(10.02 DI delayed status, bit 2).
(10.02 DI delayed status, bit 3).
(10.02 DI delayed status, bit 4).
(10.02 DI delayed status, bit 5).
(11.02 DIO delayed
(11.02 DIO delayed
Terms and abbreviations
(10.02 DI delayed status, bit 0).
(10.02 DI delayed status, bit 1).
(10.02 DI delayed status, bit 2).
(10.02 DI delayed status, bit 3).
Def/FbEq16
Knife cut
Torque boost
activated
Not selected
status, bit 0).
status, bit 1).
on
Not selected
t
0
1
2
3
4
5
6
7
8
9
-
0
1
2
3
4
5