ABB ACS880 Firmware Manual page 236

236 Parameters
No. Name/Value
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Fieldbus A
Embedded fieldbus
M/F link
DDCS controller
Application Program The start and stop commands are taken from the application
ATF
Description
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1 source
source. The source selected by
determines the direction. The state transitions of the source
bits are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
1
0 - > 1
1
Any 0
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1
and 20.10 Ext2 in3 source. The state transitions of the
source bits are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
Any
0 - > 1
Any
Any Any
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The start and stop commands are taken from the control
panel.
The start and stop commands are taken from fieldbus
adapter A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the drive-to-drive link or the master/follower link.
Note: Set also 20.07 Ext2 start trigger type
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
and 20.09 Ext2 in2
20.10 Ext2 in3 source
State of
source 3 Command
(20.10)
0 Start forward
1 Start reverse
Any Stop
20.07 Ext2 start trigger
source, 20.09 Ext2 in2 source
State of
source 3 Command
(20.10)
1 Start forward
1 Start reverse
0 Stop
20.07 Ext2 start trigger
20.07 Ext2 start trigger
20.07 Ext2 start trigger
to Level.
20.07 Ext2 start trigger
06.02 Application control
20.07 Ext2 start trigger
Def/FbEq16
5
type.
6
type.
11
12
type.
14
type.
15
16
type.
21
type.
22