ABB ACS880 Firmware Manual page 173

No. Name/Value
06.21 Drive status word 3
Bit Name
0 DC hold active
1 Post-magnetizing active 1 = Post-magnetizing is active (see par. 21.08)
2 Motor pre-heating active 1 = Motor pre-heating is active (see par 21.08)
3 PM smooth start active
4...15 Reserved
0000h...FFFFh
06.25 Drive inhibit status
word 2
Bit Name
0 Follower drive
1 Application
2 Reserved
3 Encoder
feedback
4 Ref source
parametrization
5...15 Reserved
Notes:
a If bit 1 of
and edge triggering is selected for the active external control location, a fresh rising-edge
start signal is required. See parameters 20.02,
b If bit 1 of
fresh rising-edge start signal is required.
0000h...FFFFh
06.29 MSW bit 10 sel
False
True
Above limit
Other [bit]
Description
Constant speed/frequency status word. Indicates which
constant speed or frequency is active (if any). See also
parameter 06.19 Speed control status
section Constant speeds/frequencies
This parameter is read-only.
Description
1 = DC hold is active (see par. 21.08)
Reserved.
Constant speed/frequency status word.
Drive inhibit status word 2. This word specifies the source of
the inhibiting signal that is preventing the drive from starting.
After the con
bit specific notes.
See also parameters
06.16 Drive status word
This parameter is read-only.
Description
1 = A follower drive is preventing the master from starting.
1 = The application program is preventing the drive from starting.
1 = The encoder feedback configuration is preventing the
drive from starting.
1 = A reference source parametrization conflict is preventing the
drive from starting. See warning
parametrization
06.16 Drive status word 1
06.16 Drive status word 1
Start inhibit status word 2.
Selects a binary source whose status is transmitted as bit 10
of 06.11 Main status
0.
1.
Bit 10 of 06.17 Drive status word 2
Source selection (see
152).
word, bit 7, and
(page 84).
06.18 Start inhibit status word
1, bit 1.
A6DA Reference source
(page 575).
is still set after the removal of the inhibiting condition,
20.07 and 20.19.
is still set after the removal of the inhibiting condition, a
word.
(see page 170).
Terms and abbreviations
Parameters 173
Def/FbEq16
-
1 = 1
-
and
Note
a
b
a
b
1 = 1
Above limit
0
1
2
on page -