ABB ACS880 Firmware Manual page 234

234 Parameters
No. Name/Value
Control panel
Fieldbus A
Embedded fieldbus
M/F link
DDCS controller
Application Program The start and stop commands are taken from the application
ATF
20.02 Ext1 start trigger
type
Edge
Level
20.03 Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.04 Ext1 in2 source
Description
The start and stop commands are taken from the control
panel.
The start and stop commands are taken from fieldbus
adapter A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
20.01 Ext1 commands is set to
In1 Start fwd; In2 Start rev
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
page 152).
Selects source 2 for parameter
For the available selections, see parameter
source.
20.02 Ext1 start trigger
20.02 Ext1 start trigger
20.02 Ext1 start trigger
20.02 Ext1 start trigger
06.02 Application control
20.02 Ext1 start trigger
In1 Start, In1 Start; In2
or Control panel.
20.01 Ext1 commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on
20.01 Ext1 commands.
20.03 Ext1 in1
Def/FbEq16
11
12
type.
14
type.
15
type.
16
type.
21
type.
22
Edge
Dir,
0
1
DI1
0
1
2
3
4
5
6
7
10
11
-
Not selected