ABB ACS880 Firmware Manual page 397

No. Name/Value
60.13 M/F act2 type
Auto
Transparent
General
Torque
Speed
Frequency
60.14 M/F follower
selection
None
Follower node 2
Follower node 3
Follower node 4
Follower nodes 2+3
Follower nodes 2+4
Follower nodes 3+4
Follower nodes
2+3+4
60.15 Force master
FALSE
TRUE
Other [bit]
60.16 Force follower
FALSE
TRUE
Other [bit]
60.17 Follower fault action
No action
Description
Selects the type/source and scaling of actual value ACT2
transmitted to the master/follower link.
Type/source and scaling follow the type of reference 2
selected by parameter 60.11 M/F ref2
individual settings below for the sources and scalings.
Reserved.
Reserved.
01.10 Motor torque is sent as actual value 2. The scaling is
defined by parameter 46.03 Torque
01.01 Motor speed used
scaling is defined by parameter
01.06 Output frequency
scaling is defined by parameter
(Effective in the master only.) Defines the followers from
which data is read. See also parameters 62.28...62.33.
None.
Data is read from the follower with node address 2.
Data is read from the follower with node address 3.
Data is read from the follower with node address 4.
Data is read from the followers with node addresses 2 and 3. 6
Data is read from the followers with node addresses 2 and 4. 10
Data is read from the followers with node addresses 3 and 4. 12
Data is read from the followers with node addresses 2, 3 and
4.
When parameter 60.03 M/F mode
D2D forcing, this parameter selects a source that forces the
drive to be the master on the master/follower link.
1 = Drive is master on the master/follower link
0.
1.
Source selection (see Terms and abbreviations
152).
When parameter 60.03 M/F mode
D2D forcing, this parameter selects a source that forces the
drive to be a follower on the master/follower link.
1 = Drive is follower on the master/follower link
0.
1.
Source selection (see Terms and abbreviations
152).
(Effective in the master only.) Selects how the drive reacts to
a fault in a follower.
Note: Each follower must be configured to transmit its status
word as one of the three data words in parameters
61.01...61.03. In the master, the corresponding target
parameter (62.04...62.12) must be set to
No action taken. Unaffected drives on the master/follower
link will continue running.
type. See the
scaling.
is sent as actual value 2. The
46.01 Speed scaling.
is sent as actual value 2. The
46.02 Frequency
is set to DDCS forcing
on page
is set to DDCS forcing
on page
Follower
Parameters 397
Def/FbEq16
Auto
0
1
2
3
4
5
scaling.
None
0
2
4
8
14
or FALSE
0
1
-
or FALSE
0
1
-
Fault
SW.
0