ABB ACS880 Firmware Manual page 28

28 Start-up guide for ACS880 winder control program
Define the analog inputs signal range.
With the ACS-AP-I control panel available you may use the embedded Winder Start-up
Assistant to perform a quick set-up. This is a step by step guide that leads through the
essential settings of the Winder control program.
Note: The Winder assistant script requires control panel firmware version 4.61 or later. You
can check the control panel firmware version from System info of the main menu.
Power up the drive.
Note: It is normal that warning messages
appear at various points along the start-up
process. ABB recommends that you fix all of
them before proceeding with application
setup.
After you fixed all warning messages, the
Home view appears. Press
below the display to access the Menu.
Press (Menu).
In the main Menu use
Assistants. Press
drive assistants.
In the Assistants list, choose Winder
assistant and press
application setup with assistant script.
Obey the instructions on the screen. Use
. key to access parameters
from the list and to change the selected
parameter value.
If you prefer to return to the previous screen,
.
press
12.17 AI1 min
12.18 AI1 max
12.27 AI2 min
12.28 AI2 max
Start-up Assistant
Remote
located
Options
Remote
to choose
Menu
to access the list of
Exit
Remote
to begin the
Assistants
Back
Motor speed used
rpm
Motor current
A
Motor torque
%
12:34
Parameters
Assistants
Energy efficiency
Event log
12:34
Basic setup
Winder assistant
12:34
0.0 rpm
0.00
0.00
0.0
Menu
0.0 rpm
Select
0.0 rpm
Select