ABB ACS880 Firmware Manual page 319

No. Name/Value
33.40 Edge counter 2
actual
0...4294967295
33.41 Edge counter 2
warn limit
0...4294967295
33.42 Edge counter 2
function
Bit Function
0 Counter mode
0 = Loop: When the limit is reached, the counter is reset. The counter status (bit 3 of
33.01) remains 1 until the counter is again incremented. The warning (if enabled) stays
active for at least 10 seconds.
1 = Saturate: After the limit is reached, the counter status (bit 3 of 33.01) remains 1
until
1 Warning enable
0 = Disable: No warning is given when the limit is reached
1 = Enable: A warning (see 33.45) is given when the limit is reached
2 Count rising edges
0 = Disable: Rising edges are not counted
1 = Enable: Rising edges are counted
3 Count falling edges
0 = Disable: Falling edges are not counted
1 = Enable: Falling edges are counted
4...15 Reserved
0000b...1111b
33.43 Edge counter 2
source
False
True
RO1
Other [bit]
33.44 Edge counter 2
divider
1...4294967295
Description
Displays the actual present value of signal edge counter 2.
The counter is incremented every time the signal selected
by parameter 33.43 Edge counter 2 source
off (or either, depending on the setting of
counter 2 function). A divisor may be applied to the count
(see 33.44 Edge counter 2
When the counter exceeds the limit set by
counter 2 warn limit, bit 3 of
The warning specified by
message is also given if enabled by
function.
The counter can be reset from the Drive composer PC tool,
or from the control panel by keeping Reset depressed for
over 3 seconds.
Actual present value of signal edge counter 2.
Sets the warning limit for signal edge counter 2.
Warning limit for signal edge counter 2.
Configures signal edge counter 2.
33.40 is reset. The warning (if enabled) also stays active until
Edge counter 2 configuration word.
Selects the signal to be monitored by signal edge counter 2.
0.
1.
Bit 0 of 10.21 RO status
Source selection (see
page 152).
Defines a divisor for signal edge counter 2. Determines how
many signal edges increment the counter by 1.
Divisor for signal edge counter 2.
switches on or
33.42 Edge
divider).
33.41 Edge
33.01 Counter status
33.45 Edge counter 2 warn
33.42 Edge counter 2
(page 187).
Terms and abbreviations
Parameters 319
Def/FbEq16
-
is set to 1.
-
0
-
0000b
33.40 is reset.
1 = 1
False
0
1
2
on -
1
-