ABB ACS880 Firmware Manual page 418

418 Parameters
No. Name/Value
74.51 Winder control
status
Bit Name
0 Winding mode unwinder
1 Winding direction is negative
2 Open loop Tctrl forced
3 Reserved
4 Diameter Reset command
5 Diameter Preset command
6 Count up enabled
7 Count down enabled
8 Torq memory sample
9 Torq memory enabled
10 Tension control enabled
11 Stall function enabled
12 Inertia compensation enabled
13 Friction compensation enabled 1 = Friction compensation is enabled
14 Threading forward command
15 Threading reverse command
0x0000... 0xffff
74.61 Used length
0.0... 100000.0 m
74.91 Unit system
Metric
Imperial
Description
Status word showing active control settings of the
application.
This parameter is read-only.
Val.
1 = Command to unwind
0 = Command to wind
1 = Winding direction negative
0 = Winding direction positive
1 = Force open loop control
0 = Normal operation
1 = Reset diameter
0 = Normal operation
1 = Preset diameter
0 = Normal operation
1 = Count up is enabled
0 = Count up is disabled
1 = Count down is enabled
0 = Count down is disabled
1 = Torque memory sampling is enabled
0 = Normal operation
1 = Torque memory is enabled
0 = Normal operation
1 = Regulator control is enabled
0 = Normal operation (pure speed control)
1 = Stall mode is enabled
0 = Stall mode is disabled
1 = Inertia compensation is enabled
0 = Normal operation
0 = Normal operation
1 = Command to threading forward
0 = Normal operation
1 = Command to threading reverse
0 = Normal operation
Winder control status.
Displays the material length used in software internal
calculations.
This parameter is read-only.
Material length used.
Selects the used unit system.
Uses the Metric unit system.
Uses the Imperial unit system.
Description
Def/FbEq16
0x0000
1 = 1
0.0 m
10 = 1 m
Metric
0
1