ABB ACS880 Firmware Manual page 486

486 Parameters
No. Name/Value
96.20 Time sync primary
source
Internal
DDCS Controller
Fieldbus A or B
Fieldbus A
Fieldbus B
D2D or M/F
Embedded FB
Embedded Ethernet Ethernet port on type BCU control unit.
Panel link
Ethernet tool link
96.23 M/F and D2D clock
synchronization
Inactive
Active
96.24 Full days since 1st
Jan 1980
1...59999
96.25 Time in minutes
within 24 h
1...1439
96.26 Time in ms within
one minute
0...59999
Description
Defines first priority external source for synchronizing the
drive time and date.
The date and time can also be directly set into parameters
96.24...96.26 in which case this parameter is ignored, that
is, no external source selected.
No external source selected.
External controller.
Fieldbus interface A or B.
Fieldbus interface A.
Fieldbus interface B.
The master station on a master/follower or drive-to-drive
link.
Reserved.
Control panel, or Drive composer PC tool connected to the
control panel.
Drive composer PC tool through an FENA module.
In the master drive, activates clock synchronization for
master/follower and drive-to-drive communication.
Clock synchronization not active.
Clock synchronization active.
Number of full days passed since beginning of the year
1980.
This parameter, together with
24 h and 96.26 Time in ms within one minute
possible to set the date and time in the drive via the
parameter interface from a fieldbus or application program.
This may be necessary if the fieldbus protocol does not
support time synchronization.
Days since beginning of 1980.
Number of full minutes passed since midnight. For example,
the value 860 corresponds to 2:20 pm.
See parameter 96.24 Full days since 1st Jan
Minutes since midnight.
Number of milliseconds passed since last minute.
See parameter 96.24 Full days since 1st Jan
Number of milliseconds since last minute.
96.25 Time in minutes within
makes it
1980.
1980.
Def/FbEq16
DDCS
Controller
0
1
2
3
4
5
6
7
8
9
Inactive
0
1
-
1 = 1
0 min
1 = 1
0 ms
1 = 1