Fba A Data Out; Fba B Settings - ABB ACS880 Firmware Manual

384 Parameters
No. Name/Value
53

53 FBA A data out

53.01 FBA A data out1
None
CW 16bit
Ref1 16bit
Ref2 16bit
CW 32bit
Ref1 32bit
Ref2 32bit
CW2 16bit
Other
... ...
53.12 FBA A data out12
54

54 FBA B settings

54.01 FBA B type
54.02 FBA B Par2
0...65535
... ...
54.26 FBA B Par26
0...65535
54.27 FBA B par refresh
Done
Refresh
Description
Selection of data to be transferred from fieldbus controller to
drive through fieldbus adapter A.
Note: 32-bit values require two consecutive parameters.
Whenever a 32-bit value is selected in a data parameter, the
next parameter is automatically reserved.
Parameters 53.01...53.12
the fieldbus controller to the drive through fieldbus
adapter A.
None.
Control Word (16 bits)
Reference REF1 (16 bits)
Reference REF2 (16 bits)
Control Word (32 bits)
Reference REF1 (32 bits)
Reference REF2 (32 bits)
Control Word 2 (16 bits)
Source selection (see Terms and abbreviations
152).
...
See parameter 53.01 FBA A data
Fieldbus adapter B configuration.
Displays the type of the connected fieldbus adapter module.
0 = Module is not found or is not properly connected, or is
disabled by parameter 50.31 FBA B
32 = FCAN; 37 = FDNA; 101 = FCNA, 128 = FENA-11/21;
135 = FECA; 136 = FEPL; 485 = FSCA.
This parameter is read-only.
Parameters 54.02...54.26
more information, see the documentation of the fieldbus
adapter module. Note that not all of these parameters are
necessarily in use.
Fieldbus adapter configuration parameter.
...
See parameter 54.02 FBA B
Fieldbus adapter configuration parameter.
Validates any changed fieldbus adapter module
configuration settings. After refreshing, the value reverts
automatically to Done.
Note: This parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
select data to be transferred from
on page
out1.
enable; 1 = FPBA;
are adapter module-specific. For
Par2.
Def/FbEq16
None
0
1
2
3
11
12
13
21
-
...
None
-
-
1 = 1
...
-
1 = 1
Done
0
1