ABB ACS880 Firmware Manual page 189

No. Name/Value
10.30 RO3 source
10.31 RO3 ON delay
Status of selected
source
RO status
t = 10.31 RO3 ON delay
On
t = 10.32 RO3 OFF delay
Off
0.0 ... 3000.0 s
10.32 RO3 OFF delay
0.0 ... 3000.0 s
10.51 DI filter time
0.3 ... 100.0 ms
10.99 RO/DIO control
word
Bit Name
0 RO1
1 RO2
2 RO3
3...7 Reserved
8 DIO1
9 DIO2
10...15 Reserved
0000h...FFFFh
Description
Selects a drive signal to be connected to relay output RO3.
For the available selections, see parameter
source.
Defines the activation delay for relay output RO3.
t t
On Off
Activation delay for RO3.
Defines the deactivation delay for relay output RO3. See
parameter 10.31 RO3 ON
Deactivation delay for RO3.
Defines a filtering time for parameter
Filtering time for 10.01.
Storage parameter for controlling the relay outputs and
digital input/outputs e.g. through the embedded fieldbus
interface.
To control the relay outputs (RO) and the digital
input/outputs (DIO) of the drive, send a control word with the
bit assignments shown below as Modbus I/O data. Set the
target selection parameter of that particular data
(58.101...58.124) to RO/DIO control
selection parameter of the desired output, select the
appropriate bit of this word.
Description
Source bits for relay outputs RO1...RO3 (see parameters 10.24,
and 10.30).
Source bits for digital input/outputs DIO1...DIO3 (see parameters
and 11.10).
RO/DIO control word.
10.24 RO1
t
On
delay.
10.01 DI status.
word. In the source
Parameters 189
Def/FbEq16
Fault (-1)
0.0 s
1
0
1
0
Time
t
Off
10 = 1 s
0.0 s
10 = 1 s
10.0 ms
10 = 1 ms
0000h
10.27
11.06
1 = 1