ABB ACS880 Firmware Manual page 482

482 Parameters
No. Name/Value
96.02 Pass code
0...99999999
96.03 Access levels active
Bit Name
0 End user
1 Service
2 Advanced programmer
3...10 Reserved
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 R&D access level
0000h...FFFFh
96.04 Macro select
Done
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
FIELDBUS
Description
Pass codes can be entered into this parameter to activate
further access levels (see parameter
active) or to configure the user lock.
Entering "358" toggles the parameter lock, which prevents
the changing of all other parameters through the control
panel or the Drive composer PC tool.
Entering the user pass code (by default, "10000000")
enables parameters 96.100...96.102, which can be used to
define a new user pass code and to select the actions that
are to be prevented.
Entering an invalid pass code will close the user lock if open,
i.e. hide parameters 96.100...96.102. After entering the
code, check that the parameters are in fact hidden. If they
are not, enter another (random) pass code.
Entering several invalid pass codes introduces a delay
before a new attempt can be made. Entering further invalid
codes will progressively lengthen the delay.
Note: You must change the default user pass code to
maintain a high level of cybersecurity. Store the code in a
safe place – the protection cannot be disabled even by ABB
if the code is lost.
See also section User lock
Pass code.
Shows which access levels have been activated by pass
codes entered into parameter
This parameter is read-only.
Active access levels.
Selects the application macro. See chapter
macros (page 135) for more information.
After a selection is made, the parameter reverts
automatically to Done.
Macro selection complete; normal operation.
Factory macro (see page 136).
Hand/Auto macro (see page 138).
PID control macro (see page 140).
Torque control macro (see page 144).
Sequential control macro (see page 146).
Reserved.
96.03 Access levels
(page 131).
96.02 Pass code.
Application
Def/FbEq16
0
-
0001h
-
Done
0
1
2
3
4
5
6