ABB ACS880 Firmware Manual page 255

No. Name/Value
Enabled (init at
stop/power-up)
Enabled (resume
always)
22.72 Motor potentiometer
initial value
-32768.00 ...
32767.00
22.73 Motor potentiometer
up source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
22.74 Motor potentiometer
down source
22.75 Motor potentiometer
ramp time
0.0 ... 3600.0 s
22.76 Motor potentiometer
min value
-32768.00 ...
32767.00
Description
When enabled, the motor potentiometer first adopts the
value defined by parameter
value. When the drive is operating, the value can be
adjusted from the up and down sources defined by
parameters 22.73 Motor potentiometer up source
Motor potentiometer down
A stop or a power cycle resets the motor potentiometer to
the initial value (22.72).
Functions as in Enabled (init at
the motor potentiometer value over a stop or a power cycle.
Defines an initial value (starting point) for the motor
potentiometer. See the selections of parameter
potentiometer function.
Initial value for motor potentiometer.
Selects the source of motor potentiometer up signal.
0 = No change
1 = Increase motor potentiometer value. (If both the up and
down sources are on, the potentiometer value will not
change.)
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
152).
Selects the source of motor potentiometer down signal.
0 = No change
1 = Decrease motor potentiometer value. (If both the up and
down sources are on, the potentiometer value will not
change.)
For the selections, see parameter
potentiometer up source.
Defines the change rate of the motor potentiometer. This
parameter specifies the time required for the motor
potentiometer to change from minimum (22.76) to maximum
(22.77). The same change rate applies in both directions.
Motor potentiometer change time.
Defines the minimum value of the motor potentiometer.
Motor potentiometer minimum.
22.72 Motor potentiometer initial
source.
stop/power-up), but retains
22.71 Motor
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page
22.73 Motor
Parameters 255
Def/FbEq16
1
and 22.74
2
0.00
1 = 1
Not selected
0
1
2
3
4
5
6
7
10
11
-
Not selected
60.0 s
10 = 1 s
-1500.00
1 = 1