ABB ACS880 Firmware Manual page 180

180 Parameters
No. Name/Value
07.30 Adaptive program
status
Bit Name
0 Initialized
1 Editing
2 Edit done
3 Running
4...13 Reserved
14 State changing
15 Faulted
0000h...FFFFh
07.40 IEC application Cpu
usage peak
0.0 .. 100.0%
07.41 IEC application Cpu
load average
0.0 .. 100.0%
Description
Shows the status of the adaptive program.
See section Adaptive programming
Description
1 = Adaptive program initialized
1 = Adaptive program is being edited
1 = Editing of adaptive program finished
1 = Adaptive program running
1 = State change in progress in adaptive programming engine
1 = Error in adaptive program
Adaptive program status.
(Visible only with option +N8010 [application
programmability])
Displays the peak loading of the microprocessor caused by
the application program. This parameter can, for example,
be used to check the effect of a given application program
functionality on the CPU load. The value is in percent of an
internal quota.
The value can be reset from the control panel by keeping the
Reset depressed for over 3 seconds.
Peak microprocessor loading caused by application
program.
(Visible only with option +N8010 [application
programmability])
Displays the average loading of the microprocessor caused
by the application program. The value is in percent of an
internal quota.
Average microprocessor loading caused by application
program.
(page 67).
Def/FbEq16
-
1 = 1
-
10 = 1%
-
10 = 1%