Drive Mode Indicators; Remote Sequence (Seq) Indicator - YASKAWA F7 User Manual

http://www.aotewell.com

Drive Mode Indicators

The definition of the Drive mode indicators are shown in Table 3.2.
Indicator
FWD Lit when a forward run command is input.
REV Lit when a reverse run command is input.
REMOTE SEQ See Table 3.3.
REMOTE REF See Table 3.4.
ALARM Lit when a fault has occurred. Flashes when an Alarm has occurred.

REMOTE Sequence (SEQ) Indicator

The status of the "REMOTE" Sequence (SEQ) indicator is shown in Table 3.3. This indicator is always "Off" when the Drive
is in the "LOCAL" mode. When the Drive is in the "REMOTE" mode, the SEQ indicator status is dependent on the setting of
parameter b1-02 (Run Command Selection). See Table 3.3.
Indicator Status
On
Off
Tel: +(86) 755 8660 6182
Aotewell
Table 3.2 Drive Mode Indicators
Table 3.3 REMOTE Sequence (SEQ) Indicator
Parameter b1-02 (Run Command Selection) is set to terminal strip, communications, or an option
board as indicated below:
b1-02=1 (Terminals)
=2 (Communications)
=3 (Option PCB)
Parameter b1-02 (Run Command Selection) is set to Digital Operator as indicated below:
b1-02=0 (Operator)
Digital Operator 3 - 4
Aotewell
Email: Sales@aotewell.com
Definition
Condition
http://www.aotewell.com