Huawei Quidway S8500 Series Command Manual page 97

Command Manual – Port
Quidway S8500 Series Routing Switches
SDH error:
Last 5 minutes output:
Last 5 minutes input:
input:
Output:
Table 3-1 Description on the fields of the display interface pos command
Pos2/1/1 current state
Link layer protocol current state
Physical layer is Packet over SDH,
loopback not set
Description
The Maximum Transmit Unit
Port hardware type
Link layer protocol
LCP opened, IPCP opened, OSICP
opened, MPLSCP opened
Hold timer
FCS
section layer:
line layer:
path layer:
C2(Rx) :0xcf C2(Tx): 0x16
J0(Rx): "quidway "
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00
J0(Tx): "quidway"
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00
J1(Rx): "quidway "
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00
J1(Tx): "quidway"
71 75 69 64 77 61 79 00 00 00 00 00 00 00 00 00
BER thresholds: SD = 10e-6
section layer: B1
line layer: B2
path layer: B3
0 packets/sec 1664 bits/sec
0 packets/sec 1584 bits/sec
1731 packets, 16913416468 bytes
0 errors, 0 CRC, 0 giants
0 pads, 0 aborts, 0 overflows
3953 packets, 1314756 bytes
0 errors, 0 underflows
Field
Huawei Technologies Proprietary
Chapter 3 POS Port Configuration Commands
SF = 10e-3
0
0 M1 0
0 G1 0
Current state of the POS port
Current state of the link layer protocol
The physical layer uses SDH frame
mode, and loopback is not set on the
port.
Port description
MTU
Port hardware type
Link layer protocol
Enabled protocols
Interval time of the hold timer
Check mode
3-4
*quidway.........*
*quidway.........*
*quidway.........
*quidway.........*
0%
0%
Description