Huawei Quidway S8500 Series Command Manual page 62

Command Manual – Port
Quidway S8500 Series Routing Switches
The Maximum Frame Length is 1552
Broadcast MAX-ratio: 100%
Allow jumbo frame to pass
MixInsert-Port VPN status:not enable MixInsert access
PVID: 48
Mdi type: auto
Port link-type: access
Tagged
Untagged VLAN ID : 48
Last 300 seconds input:
Last 300 seconds output:
Input(total):
Input(normal):
Input:
Output(total): 1 packets, 64 bytes
Output(normal): 1 packets, 64 bytes
Output: 0 output errors,
Receive Packet Peak Value Info: 7215 bytes, happened at 03:30:35 3-7-2001
Transmit Packet Peak Value Info: 64 bytes, happened at 03:30:35 3-7-2001
Table 1-1 Description on the fields of the display interface command
Ethernet2/1/1 current state
IP Sending Frames' Format
Hardware address
The Maximum Transmit Unit
Media type
loopback not set
Port hardware type
100 Mbps-speed
mode
Link speed type is autonegotiation, link
duplex type is autonegotiation
VLAN ID : none
0 packets/sec 61 bits/sec
0 packets/sec 0 bits/sec
54 packets, 7465 bytes
42 broadcasts, 5 multicasts
54 packets, 7465 bytes
- broadcasts, - multicasts
0 input errors, 0 runts, 0 giants,
0 frame, 0 overruns, - aborts, 0 ignored, - parity errors
0 broadcasts, 0 multicasts, 0 pauses
- broadcasts, - multicasts, 0 pauses
- underruns, - buffer failures
0 aborts, 0 deferred, - collisions, 0 late collisions
- lost carrier, - no carrier
Field
mode, full-duplex
Huawei Technologies Proprietary
Chapter 1 Ethernet Port Configuration Commands
0 throttles, 0 CRC
The current status of Ethernet port
(enabled or disabled)
Ethernet frame format
Port hardware address
Maximum transmit unit
Type of media
Port loopback test status
Port hardware type
Both the duplex mode and the rate are
set to auto-negotiation. The rate of 100
Mbps and the mode of full-duplex are
adopted after negotiating with its peer
1-6
1%
1%
Description