Huawei Quidway S8500 Series Command Manual page 63

Command Manual – Port
Quidway S8500 Series Routing Switches
Flow-control is not enabled
The Maximum Frame Length
Broadcast MAX-ratio
Allow jumbo frame to pass
Port VPN status
PVID
Mdi type
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Last 300 seconds input: 0 packets/sec 0
bits/sec
Last 300 seconds output: 0 packets/sec
0 bits/sec
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input(normal): 0 packets, 0 bytes
- broadcasts, - multicasts
Input: 0 input errors, 0 runts, 0 giants, 0
throttles, 0 CRC
0 frame, 0 overruns, - aborts, 0
ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0
pauses
Output(normal): 0 packets, 0 bytes
- broadcasts, - multicasts, 0
pauses
Output: 0 output errors, - underruns, -
buffer failures
0 aborts, 0 deferred, - collisions, 0
late collisions
- lost carrier, - no carrier
Chapter 1 Ethernet Port Configuration Commands
Field
Huawei Technologies Proprietary
1-7
Description
Port flow control status
Maximum length of the Ethernet frames
that can pass the port
Port broadcast storm suppression ratio
Jumbo frame is allowed to pass the port
Port VPN status (enable or not VPN
access)
Port default VLAN ID
Cable type
Port link type
The VLANs with packets tagged
The VLANs with packets untagged
The input/output rate and the passing
packet number on this port in the last
300 seconds.
The statistics information of input/output
packets and errors on this port. "-"
indicates that the item doesn't supported
by the switch.