Huawei Quidway S8500 Series Command Manual page 163

Command Manual – VLAN&QinQ
Quidway S8500 Series Routing Switches
join: GARP Join timer. GARP application entity will send out Join message after the
Join timer goes timeout to make other GARP application entity register its own
information.
leave: GARP Leave timer . When a GARP application entity wants to deregister certain
attribute information, it sends Leave message. The GARP application entity receiving
the message starts Leave timer. If the entity receives no Join message before the timer
goes timeout, it will deregister the attribute information.
timer-value: Value of GARP hold timer, join timer and leave timer in centiseconds. The
step is five centiseconds. By default, Hold timer is 10 centiseconds, Join timer is 20
centiseconds, Leave timer is 60 centiseconds.
The range conforms to the following rule:
The value of Join timer should be no less than the doubled value of Hold timer.
The value of Leave timer should be greater than the doubled value of Join timer
and smaller than the Leaveall timer value.
The minimal value of Join timer is 10 centiseconds.
Description
Use the garp timer command to set the value of GARP timer (including Hold timer, Join
timer and Leave timer) of the port.
Use the undo garp timer command to restore the default value of GARP timer.
The value range of a timer varies with the values of other timers. So if the value of a
timer you want to set is not within the available value range, you can change the value
range by changing the values of other related timers.
The lower limit of Hold timer is 10 centiseconds. You can change its upper limit by
changing the value of Join timer.
You can change the lower limit and upper limit of Join timer by changing the value
of Hold timer and Leave timer respectively.
You can change the lower limit and upper limit of Leave timer by changing the
value of Join timer and LeaveAll timer respectively.
The upper limit of LeaveAll timer is 32765 centiseconds. You can change its lower
limit by changing the value of Leave timer.
Related command: display garp timer.
Example
# Set Join timer of GARP to 300ms.
[Quidway-Ethernet2/1/1] garp timer join 30
Chapter 2 GARP/GVRP Configuration Commands
Huawei Technologies Proprietary
2-3