Huawei Quidway S8500 Series Command Manual page 110

Command Manual – Port
Quidway S8500 Series Routing Switches
information, including the status information about RPR POS logical and physical ports.
If you specify port number, the command displays the information about the specified
port. By viewing the information about physical ports, you can monitor the SDH physical
layer and performance. For example, you can monitor basic alarms such as out of
frame (OOF), loss of frame (LOF).
Example
# Display the configuration information of the RPR2/1/1 Ethernet port (logical port
information).
<Quidway> display interface RPR2/1/1
RprPos2/1/1 current state : DOWN
Including two physical rpr interface:
rprpos2/1/1.1, rprpos2/1/1.2,
Rpr station name is
Rpr bridge MAC address is 00e0-fc00-85ff
Rpr configured default ringlet is
RPR work mode
IP address of RPR Access VLAN's interface is: NULL
IP Mask of RPR Access VLAN's interface is: NULL
Link-status hold interval:3 Sec
Description:
The Maximum Transmit Unit is 1536 ,Loopback not set
10G speed mode and full duplex mode
Flow-control is not enabled
The Maximum Frame Length is 1552
Broadcast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Port link-type: access
Tagged
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total):
Input(normal):
Input:
Output(total): 0 packets, 0 bytes
Output(normal): 0 packets, 0 bytes
NULL
NORMAL
RprPos2/1/1 Interface
VLAN ID : none
0 packets/sec 0 bits/sec
0 packets/sec 0 bits/sec
0 packets, 0 bytes
0 broadcasts, 0 multicasts
0 packets, 0 bytes
- broadcasts, - multicasts
0 input errors, 0 runts, 0 giants,
0 frame, 0 overruns, - aborts, 0 ignored, - parity errors
0 broadcasts, 0 multicasts, 0 pauses
Huawei Technologies Proprietary
Chapter 4 RPR Port Configuration Commands
0
0 throttles, 0 CRC
4-3
1%
1%