| Security Measures
C
13
HAPTER
Access Control Lists
C
ONFIGURING A
MAC ACL
Select the name of an ACL from the Name list.
5.
Specify the action (i.e., Permit or Deny).
6.
Select the address type (Any or IPv6-prefix).
7.
If you select "Host," enter a specific address. If you select "IPv6-prefix,"
8.
enter a subnet address and prefix length.
Set any other required criteria, such as DSCP, next header type, or flow
9.
label.
Click Apply.
10.
Figure 207: Configuring an Extended IPv6 ACL
Use the Security > ACL (Configure ACL - Add Rule - MAC) page to
configure a MAC ACL based on hardware addresses, packet format, and
Ethernet type.
CLI R
EFERENCES
"permit, deny (MAC ACL)" on page 1177
◆
"show ip access-list" on page 1169
◆
"Time Range" on page 957
◆
P
ARAMETERS
These parameters are displayed:
Type – Selects the type of ACLs to show in the Name list.
◆
Name – Shows the names of ACLs matching the selected type.
◆
Action – An ACL can contain any combination of permit or deny rules.
◆
– 404 –