Edge-Core ECS4660-28F Management Manual page 400

| Security Measures
C 13
HAPTER
Access Control Lists
C
ONFIGURING A
S IP 6 ACL
TANDARD V
Select the name of an ACL from the Name list.
5.
Specify the action (i.e., Permit or Deny).
6.
Select the address type (Any, Host, or IP).
7.
If you select "Host," enter a specific address. If you select "IP," enter a
8.
subnet address and the mask for an address range.
Set any other required criteria, such as service type, protocol type, or
9.
control code.
Click Apply.
10.
Figure 205: Configuring an Extended IPv4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Standard) page to
configure a Standard IPv6ACL.
CLI R
EFERENCES
"permit, deny (Standard IPv6 ACL)" on page 1171
◆
"show ipv6 access-list" on page 1175
◆
"Time Range" on page 957
◆
P
ARAMETERS
These parameters are displayed in the web interface:
Type – Selects the type of ACLs to show in the Name list.
◆
Name – Shows the names of ACLs matching the selected type.
◆
Action – An ACL can contain any combination of permit or deny rules.
◆
– 400 –