Table 24: Arp Inspection Statistics - Edge-Core ECS4660-28F Management Manual

| Security Measures
C 13
HAPTER
ARP Inspection
D
ISPLAYING
ARP I
NSPECTION
S
TATISTICS
W I
EB NTERFACE
To configure interface settings for ARP Inspection:
Click Security, ARP Inspection.
1.
Select Configure Interface from the Step list.
2.
Specify any untrusted ports which require ARP inspection, and adjust
3.
the packet inspection rate.
Click Apply.
4.
Figure 214: Configuring Interface Settings for ARP Inspection
Use the Security > ARP Inspection (Show Information - Show Statistics)
page to display statistics about the number of ARP packets processed, or
dropped for various reasons.
CLI R
EFERENCES
"show ip arp inspection statistics" on page 1153
◆
P
ARAMETERS
These parameters are displayed:

Table 24: ARP Inspection Statistics

Parameter
Received ARP packets before
ARP inspection rate limit
Dropped ARP packets in the
process of ARP inspection rate
limit
Total ARP packets processed
by ARP inspection
ARP packets dropped by
additional validation
(Src-MAC)
ARP packets dropped by
additional validation
(Dst-MAC)
– 416 –
Description
Count of ARP packets received but not exceeding the ARP
Inspection rate limit.
Count of ARP packets exceeding (and dropped by) ARP rate
limiting.
Count of all ARP packets processed by the ARP Inspection
engine.
Count of packets that failed the source MAC address test.
Count of packets that failed the destination MAC address test.