Overview; Major Adjustments - Canon Staple Finisher-D1 Service Manual

5
Adjustment > Overview > Major Adjustments

Overview

Overview
You can perform the service mode adjustments using the SW1 (push switch), SW2 (push
switch), SW3 (DIP switch), LED1, an LED2 on the finisher controller PCB.
LED1
LED2
SW1
SW3
SW2
5 Adjustment > Overview > Major Adjustments
Detail Description
After turning on finisher with all SW3 keys set to OFF, select a service mode adjustment item
by setting the SW3 keys to ON/OFF, and then press the SW1 continuously for two seconds to
start the selected service mode adjustment. To exit from the service mode, press the SW1 or
SW2 continuously for two seconds.
When not in the service mode, the LED1 blinks at intervals of 0.5 second.
When in the service mode, the LEDs illuminate as discussed later.

Major Adjustments

Adjustments to be made to improve the stacked paper alignment performance are listed
below.
Machine Block Adjustment Item
Puncher Unit
Paper Bump Amount Adjustment at the high-accuracy
punch mode
Processing Paper Return Roller Descension Timing Adjustment
Tray Unit
F-5-1 F-5-1
Stack Delivery Upper Roller Ascension Timing
(when stacking
Adjustment
the buffered
Paper Switchback Position Adjustment
paper to the
processing tray
Paper Return Roller Ascension (Angle) Amount
unit.)
Adjustment
Buffer Operation Enable/Disable Mode Setting
5-2
Refer to
Refer to page
5-3
Refer to page
5-4
Refer to page
5-5
Refer to page
5-6
Refer to page
5-7
Refer to page
5-8
T-5-1 T-5-1
5-2