Removing The Folding Rollers (Upper)/(Lower) - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Other Parts > Removing the Folding Rollers (Upper)/(Lower)

Removing the Folding Rollers (Upper)/(Lower)

3) Release the harness from the wire saddles and disconnect the connector. Remove the 3 screws and
1) Remove the saddle
cover. then remove the saddle handle unit.
(Refer to page
4-22)
2) Remove the
alignment roller.
x4
(Refer to page
4-71)
x1
x3
5) Remove the pulleys, belt, gears, E ring and spring.
6) Remove the C ring, gear, bearing and then the pressure plate (upper) in the front side.
4 Parts Replacement and Cleaning Procedure > Other Parts > Removing the Folding Rollers (Upper)/(Lower)
4) Release the harness from the wire saddle and disconnect the 2 connectors.
Remove the 6 screws and then remove the unit fixing base (front) unit.
x2
x2
x6
F-4-183
F-4-185
4-75
F-4-184
4-75