Toshiba e-STUDIO 5540C Service Manual page 1467

e-STUDIO5540C/6540C/6550C
05/08 Mode Element Sub Element
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System General
mode
08 Setting Mode
Item Subitem Code
Card reader 3500
Card reader 3501
Card reader 3502
Card reader 3503
Card reader 3504
Available profile 3600
display
Sub- Default
Details
Code value
Device setting 0
Format information 1 0
Format information 2 0
Format information 3 0
Card authentication LDAP 0
server
0 BP_IS34_00.icc
25
Acceptable
RAM Contents
value
0~4294967 SYS To enable the e-Bridge ID Gate, a card reading
295 device should be set in the order of "ABYYZZZZ".
(Enter the corresponding values to "A", "B", "YY"
and "ZZZZ".)
- AB: Special setting
- A: Debugging NIC
0: Not used 1: Used
- B: Interface
0: USB connection 1: Serial connection (KP-
2003 only)
- YY: Authentication
00: No authentication using card
03: Mifare (KP-2005 only)
04: HID (KP-2004 only)
06: KB Emulation I/F Reader
07: 3Track Magnetic Swipe Reader
09: 2Track Magnetic Swipe Reader
- ZZZZ: Sub-code (Specifies the usage type of card
ID)
0000: No authentication using card
0001: IDm (Felica/NFC-Felica) and (or) UID
(Mifare/NFC-Mifare)
0002: Data (Felica/NFC-Felica/Mifare/NFC-Mifare)
0003: SSFC mode
0~4294967 SYS To access the data in the noncontact IC card, the
295 Key Information "LLLL" and the Sector Number
"MMMM" should be set. The "LLLL" should be set
first, and then "MMMM".
<KP-2005>
LLLL: Key information
MMMM: Sector number (hexadecimal number)
0~4294967 SYS The data of the block number in the noncontact IC
295 is set.
<KP-2005>
RRBSEbse (hexadecimal number)
RR: 00 (Fixed)
B: 1st area block number
S: 1st area beginning byte offset
E: 1st area ending byte offset
b: 2nd area block number
s: 2nd area beginning byte offset
e: 2nd area ending byte offset
* If the 2nd block/area is not used, set the SSTU to
"FFFF" (hexadecimal number), the bse to"FFF"
(hexadecimal number).
Refer to SYS Security key "KKKKKKKKKKKK" (12 digits)
contents <hexadecimal number> in the [Key Information] of
the [Sector Number] set in the code 08-3501
should be entered.
<Acceptable value>
0-0xFFFFFFFFFFFFFFFF
0~100 SYS LDAP server number for the card authentication
when a noncontact IC card is used should be set.
SYS Displays PG DevicePureGrayTRC attribute for the
current RGBInkSim profile and the same sub-code.
Proc
ServiceUI
edure
5 Yes
5 Yes
5 Yes
5 Yes
1
14
Ver11