one signal that is output as INT3.
An interrupt mask can be separately set for each of the interrupt factors, and the statuses before and after the
masks are applied can be read out.
The Edge interrupt factor can be cleared. In addition, depending on the interrupt factor, Level/Edge selection is
possible.
Figure SCU (Sensor Control Unit)-57 shows the connections of the INT_SEL.
SCU_REG
SPI
I2C0
I2C1
SCU_ADCIF
SCU_FIFO
SCU_SEQ_CTRL
SCU_PWM 0~7
Configuration
Data(ex. EN,CLR,etc.)
SCU_INT_SEL
Figure SCU (Sensor Control Unit)-57 Interrupt Connections
-256/1010-
PWD_SCU
4
CXD5602 User Manual
M0/M4 CPU