ErrEn
0
1
If 1'b0 is set on ErrEn,
an interrupt request is disabled. However, status register AlmFlg.ErrFlg1 transitions to 1'b1 if conditions
are met.
bit[31] : ErrDbg (Current Enable Signal Value)
This register is used for debugging. By reading this register, you can see Enable Signal value for the Error
Alarm1 Interrupt that is currently used in RTC. By using this register, you can check whether the set value
has been normally reflected on AlmOutEn1.ErrEn or not.
Description of Functions
Writing 0: disables an interrupt request to processor.
Even if conditions are met, interrupt will be deasserted.
Writing 1: enables an interrupt request to processor.
If conditions are met, interrupt will be asserted.
-195/1010-
CXD5602 User Manual