Subaru Legacy 2003 Service Manual page 3298

15.Hill Holder
A: REMOVAL
1. PHV (PRESSURE HOLD VALVE)
1) Drain brake fluid from reservoir of master cylin-
der.
2) Remove adjusting nut and lock nut.
( 3 )
(1) Adjusting nut
(2) Lock nut
(3) PHV
3) Remove cable clamp, and disconnect PHV ca-
ble from PHV.
CAUTION:
Carefully protect boots and inner cable from
damage when disconnecting PHV cable.
( 1 )
( 2 )
(1) PHV cable
(2) Clamp
4) Disconnect brake pipes from PHV.
CAUTION:
• Pay attention not to drop brake fluid onto
body painting since it may dissolve paint.
• Pay attention not to damage hexagonal head
of flare nut by using pipe wrench without fail.
HILL HOLDER
( 1 )
( 2 )
BR-00131
BR-00132
5) Detach PHV along with support from side frame.
CAUTION:
Exercise utmost care to prevent foreign matter
from entering into PHV when removing it.
2. PHV CABLE
1) Remove adjusting nut and lock nut.
(1) Adjusting nut
(2) Lock nut
(3) PHV
2) Remove cable clamp, and disconnect PHV ca-
ble from PHV.
CAUTION:
Carefully protect boot and inner cable from
damage when disconnecting PHV cable.
( 1 )
(1) PHV cable
(2) Clamp
3) Remove clutch pedal. <Ref. to CL-33, REMOV-
AL, Clutch Pedal.>
BR-47
BR-00133
( 1 )
( 2 )
( 3 )
( 2 )
BR-00132
BRAKE
BR-00131