Subaru Legacy 2003 Service Manual page 3304

Hide thumbs Also See for Legacy 2003:

Table of Contents

1) Attach stop light switch, etc. to pedal bracket

temporarily.

2) Clean inside of bores of clutch pedal and brake

pedal, apply grease, and set bushings into bores.

3) Align bores of pedal bracket, clutch pedal and

brake pedal, attach brake pedal return spring and

clutch pedal effort reducing spring (vehicle with hill

holder), and then install pedal bolt.

Clean up inside of bushings and apply grease be-

fore installing spacer.

Tightening torque:

T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)

4) Set brake pedal position by adjusting position of

stop light switch.

Pedal position: L

LHD: 126.4 mm (4.98 in)

RHD: 154.9 mm (6.10 in)

Tightening torque:

T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)

E: INSPECTION

1) Move brake and clutch pedal pads in the lateral

direction with a force of approximately 10 N (1 kgf,

2 lb) to ensure pedal deflection is in specified

If excessive deflection is noted, replace bush-

ings with new ones.

Deflection of brake and clutch pedal:

Service limit

5.0 mm (0.197 in) or less

(1) Clutch pedal

(2) Brake pedal

(1) Brake pedal

Chapters

Table of Contents