Subaru Legacy 2003 Service Manual page 3299

BRAKE
4) Remove PHV cable.
( 4 )
(1) Snap ring
(2) Clutch pedal
(3) Clamp
(4) PHV cable
HILL HOLDER
( 2 )
( 1 )
( 3 )
BR-00222
B: INSTALLATION
1. PHV (PRESSURE HOLD VALVE)
1) Install PHV onto side frame.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2) Connect brake pipes to PHV.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
CAUTION:
Confirm that brake pipes are not deformed and/
or damaged. Replace them with new ones if
necessary.
3) Install PHV cable to PHV.
CAUTION:
If cable clamp (and clips) is damaged, replace it
with a new one.
4) Connect PHV cable with clips.
NOTE:
Avoid sharp bending of PHV cable as it may cause
breakage.
5) Apply grease to the following points.
• Hook portion of return spring
• Cable end portion of lever
Grease:
SUNLIGHT 2 (Part No. 003602010)
6) Be sure to bleed air from the brake system.
7) Adjust PHV cable. <Ref. to BR-49, Adjustment.>
CAUTION:
After replacing PHV cable with new one, oper-
ate clutch pedal about 30 times as a running-in
operation prior to adjustment.
2. PHV CABLE
1) Install PHV cable in the reverse order of remov-
al.
CAUTION:
• If cable clamp is damaged, replace it with a
new one.
• Avoid sharp bending of PHV cable as it may
cause breakage.
2) Apply grease to the following points.
• Hook portion of return spring
• Cable end portion of lever
Grease:
SUNLIGHT 2 (Part No. 003602010)
3) Adjust PHV cable. <Ref. to BR-49, Adjustment.>
CAUTION:
After replacing PHV cable with new one, oper-
ate clutch pedal about 30 times as a running-in
operation prior to adjustment.
BR-48