Subaru Legacy 2003 Service Manual page 3318

4. Parking Brake Assembly
A: REMOVAL
1) Remove the two mounting bolts and remove the
disc brake assembly.
2) Suspend the disc brake assembly so that the
hose is not stretched.
3) Pull down and release parking brake.
4) Remove the disc rotor.
NOTE:
If the disc rotor is difficult to remove, try the follow-
ing two methods in order.
(1) Turn adjusting screw using a slot-type
screwdriver until brake shoe gets away enough
from the disc rotor.
( 2 )
( 1 )
( 4 )
(1) Adjusting screw
(2) Cover (rubber)
(3) Slot-type screwdriver
(4) Back plate
PARKING BRAKE ASSEMBLY
PB-00027
( 3 )
BR-00155
(2) If disc rotor seizes up within hub, drive disc
rotor out by installing an 8-mm bolt in holes B on
the rotor.
A
5) Remove shoe return spring from parking brake
assembly.
6) Using a standard screwdriver, remove front shoe
hold-down spring and pin.
7) Remove strut and strut spring.
8) Remove adjuster assembly from parking brake
assembly.
9) Using a standard screwdriver, remove rear shoe
hold-down spring and pin.
10) Remove brake shoe.
11) Remove parking cable from parking lever.
(1) Parking brake cable
(2) Parking brake lever
12) Using a standard screwdriver, raise retainer.
Remove parking lever and washer from brake
shoe.
PB-9
PARKING BRAKE
B
BR-00036
PB-00028
( 1 )
( 2 )
PB-00014