Quick Menu, Q4 Smartstart; Main Menu Mode; Parameter Selection; Changing Data - Danfoss VLT AQUA Drive FC 202 Programming Manual

How to Program

2.2.8 Quick Menu, Q4 SmartStart

SmartStart runs automatically on the first power-up of the
frequency converter or after a reset to factory settings.
SmartStart guides users through a series of steps to ensure
the correct and most efficient motor control. SmartStart
can also be started directly via the Quick Menu.
The following settings are available via SmartStart:
•
Single pump/motor: In open loop or closed loop.
•
Motor alternation: 2 motors share 1 frequency
converter.
•
Basic cascade control: Speed control of a single
pump in a multi-pump system.
For example, this can be a cost-effective solution
in booster sets.
•
Master/slave: Control of up to 8 frequency
converters and pumps to ensure smooth
operation of the overall pump system.

2.2.9 Main Menu Mode

Press [Main Menu] to enter the main menu mode. The
readout in Illustration 2.15 appears on the display.
The middle and bottom sections in the display show a list
of parameter groups, which can be selected by toggling
▲ ▼
the [ ] and [ ] keys.
1107 RPM
Main Menu
0-** Operation/Display
1-** Load/Motor
2-** Brakes
3-** References/Ramps
Illustration 2.15 Main Menu Mode
Each parameter has a name and number, which remain the
same regardless of the programming mode. In the main
menu mode, the parameters are divided into groups. The
first digit of the parameter number (from the left) indicates
the parameter group number.
All parameters can be changed in the Main Menu.
However, depending on the configuration
(parameter 1-00 Configuration Mode), some parameters can
be hidden. For example, open loop hides all the PID
parameters, and other enabled options make more
parameter groups visible.
MG20OB02
Programming Guide
3.84 A
1(1)
Danfoss A/S © 05/2018 All rights reserved.

2.2.10 Parameter Selection

In the main menu mode, the parameters are divided into
groups. Select a parameter group with the navigation keys.
After selecting a parameter group, select a parameter with
the navigation keys.
The middle section on the display shows the parameter
number and name, and the selected parameter value.
740RPM
Basic Settings
0 -01 Language
[0] English
Illustration 2.16 Parameter Selection

2.2.11 Changing Data

The procedure for changing data is the same in the quick
menu mode and the main menu mode. Press [OK] to
change the selected parameter.
The procedure for changing data depends on whether the
selected parameter represents a numeric data value or a
text value.

2.2.12 Changing a Text Value

If the selected parameter is a text value, change the text
▲ ▼
value with the [ ] [ ] keys.
Place the cursor on the value to save and press [OK].
740RPM
Basic Settings
0 -01 Language
[0] English
Illustration 2.17 Changing a Text Value
2
10.64A 1 [1]
0-0 *
10.64 A 1 [1]
0-0 *
21
2