How To Program; The Graphical And Numerical Local Control Panel; How To Program On The Graphical Lcp - Danfoss VLT AQUA Drive FC 202 Programming Manual

How to Program

2 How to Program
2.1 The Graphical and Numerical Local
Control Panel
Easy programming of the frequency converter is done via
the graphical LCP (LCP 102). For information about using
the numerical local control panel (LCP 101), see
chapter 2.2.17 How to Program on the Numerical Local
Control Panel.

2.2 How to Program on the Graphical LCP

The LCP is divided into 4 functional groups:
1. Graphical display with status lines.
2. Menu keys and indicator lights - changing
parameters and switching between display
functions.
3. Navigation keys and indicator lights.
4. Operation keys and indicator lights.
The LCP display can show up to 5 items of operating data
while showing Status.
Display lines:
Status line: Status messages showing icons and
a.
graphics.
b. Line 1–2: Operator data lines showing data
defined or selected. Add up to 1 extra line by
pressing [Status].
Status line: Status messages showing text.
c.
NOTICE
If start-up is delayed, the LCP shows the INITIALIZING
message until it is ready. Adding or removing options
can delay the start-up.
MG20OB02
Programming Guide
1
2
On
3
Warn.
Alarm
4
Illustration 2.1 LCP
Danfoss A/S © 05/2018 All rights reserved.
Status
1234rpm 10,4A 43,5Hz
43,5Hz
Run OK
Quick Main
Status
Menu Menu
OK
Hand Auto
Off
On On
2
a
1(0)
b
c
Alarm
Log
Reset
13
2