Danfoss VLT AQUA Drive FC 202 Programming Manual page 17

How to Program
The function set-up provides quick access to all parameters
required for most water and wastewater applications
including:
•
Variable torque.
•
Constant torque.
•
Pumps.
•
Dosing pumps.
•
Well pumps.
•
Booster pumps.
•
Mixer pumps.
•
Aeration blowers.
•
Other pump.
•
Fan applications.
Among other features, it also includes parameters for
selecting the following:
•
Which variables to show on the LCP.
•
Digital preset speeds.
•
Scaling of analog references.
•
Closed-loop single-zone and multi-zone
applications.
•
Specific functions related to water.
•
Wastewater applications.
The quick menu Q7: Water and Pumps provides direct
access to some of the most important dedicated water and
pump features:
•
Q7-1: Special ramps (initial ramp, final ramp,
check valve ramp).
•
Q7-2: Sleep mode.
•
Q7-3: Deragging.
•
Q7-4: Dry Run.
•
Q7-5: End of Curve Detection.
•
Q7-6: Flow Compensation.
•
Q7-7: Pipe Fill (Horizontal Pipes, Vertical Pipes,
Mixed Systems).
•
Q7-8: Control Performance.
•
Q7-9: Min. Speed Monitor.
The Quick Menu parameters can be accessed immediately,
unless a password was created via 1 of the following
parameters:
•
Parameter 0-60 Main Menu Password.
•
Parameter 0-61 Access to Main Menu w/o Password.
•
Parameter 0-65 Personal Menu Password.
•
Parameter 0-66 Access to Personal Menu w/o
Password.
It is possible to switch directly between Quick Menu mode
and Main Menu mode.
MG20OB02
Programming Guide
[Main Menu]
This section is used for programming all parameters.
The Main Menu parameters can be accessed immediately
unless a password has been created via 1 of the following
parameters:
•
•
•
•
For most water and wastewater applications, it is not
necessary to access the Main Menu parameters. The Quick
Menu, quick set-up, and function set-ups provide the
simplest and quickest access to the typical required
parameters.
It is possible to switch directly between Main Menu mode
and Quick Menu mode.
To create a parameter shortcut, press [Main Menu] for 3 s.
The parameter shortcut allows direct access to any
parameter.
[Alarm Log]
Shows an alarm list of the 5 latest alarms (numbered A1–
A5). To obtain more details about an alarm, press the
navigation keys to navigate to the alarm number and press
[OK]. Just before entering the alarm mode, information
about the condition of the frequency converter is
provided.
Status
On
Warn.
Alarm
Hand
Illustration 2.5 LCP
[Back]
Reverts to the previous step or layer in the navigation
structure.
Danfoss A/S © 05/2018 All rights reserved.
Parameter 0-60 Main Menu Password.
Parameter 0-61 Access to Main Menu w/o Password.
Parameter 0-65 Personal Menu Password.
Parameter 0-66 Access to Personal Menu w/o
Password.
Quick Main
Menu Menu
OK
Auto
O
on
on
2
Alarm
Log
Reset
15
2