How To Program; Local Control Panel; How To Operate The Graphicallcp (Glcp) - Danfoss VLT FC 100 Series Programming Manual

How to Program

2 How to Program

2.1 Local Control Panel

2.1.1 How to Operate the GraphicalLCP
(GLCP)
The following instructions are valid for the GLCP (LCP 102).
The GLCP is divided into four functional groups
1. Graphical display with Status lines.
2. Menu keys and indicator lights (LEDs) - selecting
mode, changing parameters and switching
between display functions.
3. Navigation keys and LEDs (LEDs).
4. Operation keys and LEDs.
Graphical display
The LCD-display is back-lit with a total of 6 alpha-numeric
lines. All data is displayed on the LCP which can show up
to five operating variables while in [Status] mode.
Display lines
a. Status line Status messages displaying icons and
graphics.
b. Line 1-2: Operator data lines displaying data and
variables defined or chosen by the user. By
pressing the [Status] key, up to one extra line can
be added.
c. Status line: Status messages displaying text.
®
VLT HVAC Drive Programming Guide
1
2
3
4
Figure 2.1
The display is divided into three sections.
Top section (a) shows the status when in status mode or
up to two variables when not in status mode and in the
case of Alarm/Warning.
The number of the Active Set-up (selected as the Active
Set-up in 0-10 Active Set-up) is shown. When programming
in another set-up than the Active Set-up, the number of
the set-up being programmed appears to the right in
brackets.
MG11CD22 - VLT ® is a registered Danfoss trademark
Status
1234rpm 10,4A
43,5Hz
Run OK
Quick Main
Status
Menu Menu
OK
On
Warn.
Alarm
Hand Auto
O
on on
2
a
1(0)
43,5Hz
b
c
Alarm
Log
Reset
2-1
2