Table of Contents
Advertisement
51–10
9.
REMOVE POWER STEERING SUCTION PORT UNION
(a)
Remove the bolt and the suction port union.
(b)
Remove the O–ring from the suction port union.
11.
REMOVE POWER STEERING OIL PRESSURE SWITCH
NOTICE:
If the oil pressure switch is dropped or damaged, replace it with a new one.
14.
REMOVE VANE PUMP ROTOR
(a)
Remove the 10 vane pump plates.
(b)
Remove the vane pump rotor.
15.
REMOVE VANE PUMP CAM RING
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
–
VANE PUMP ASSY (AZ Series)
10.
REMOVE FLOW CONTROL VALVE ASSY
(a)
Remove the pressure port union sub–assy.
(b)
Remove the O–ring from the pressure port union sub–
assy.
(c)
Remove the flow control valve assy and the compression
spring.
F42475
12.
REMOVE VANE PUMP HOUSING SUB–ASSY REAR
(a)
Remove the 4 bolts and housing sub–assy rear from the
housing sub–assy front.
(b)
Remove the O–ring from the housing sub–assy rear.
C84483
13.
REMOVE W/PULLEY SHAFT SUB–ASSY
(a)
Using 2 screwdrivers, remove the snap ring from the w/
pulley shaft sub–assy.
(b)
Remove the w/pulley shaft sub–assy.
C57767
http://vnx.su
Advertisement
Table of Contents
