Toyota Avensis ZZT251 2003 Service And Repair Manual page 1476

45_
Lock
Protrusion Part
Protrusion Part
Unlock
45_
Lock
AVENSIS REPAIR MANUAL (RM1018E)
SEAT BELT
(b) Check the degree of tilt when the belt begins to lock the
ELR.
NOTICE:
Unlock
Do not disassemble the retractor.
(1)
If operation is not as specified, replace the belt assy.
(c) Install the belt with the bolt on the floor anchor side.
Torque: 42 N m (430 kgf cm, 31 ft lbf)
(d) Check the ELR lock.
NOTICE:
The check should be performed with the assembly
installed.
B70206
(1)
HINT:
The seat belt does not lock when it is pulled out to a length of
955 mm (37.60 in.) or less.
If operation is not as specified, replace the belt assy.
(e) Check the fastening function of the child restraint system.
NOTICE:
The check should be performed with the assembly
installed.
(1)
(2)
If operation is not as specified, replace the belt assy.
18. INSTALL REAR SEAT 3 POINT TYPE BELT ASSY
INNER
Front
(a) Install the floor anchor and belt with the bolt as shown in
Mark
the illustration.
Torque: 42 N m (430 kgf cm, 31 ft lbf)
NOTICE:
Make sure that the anchor part does not run onto the protru-
Front
sion part of the floor panel.
B66570
19. INSTALL REAR SEAT 3 POINT TYPE BELT ASSY
OUTER
(a) Install the belt with the bolt on the retractor side.
Torque:
7.5 N m (76.5 kgf cm, 66 in. lbf) for front bolt
42 N m (430 kgf cm, 31 ft lbf) for upper bolt
(b) Check the degree of tilt when the belt begins to lock the
ELR.
NOTICE:
B70207
Do not disassemble the retractor.
http://vnx.su
– REAR SEAT BELT (SEDAN MODELS)
Check that the belt does not lock within 15_ of tilt in
all directions but locks with over 45_ of tilt when
gently moving the retractor.
Check that the belt locks by pulling it out quickly af-
ter installation.
Check that the belt cannot be pulled out any more
but rewinds after being pulled out fully.
Check that the belt can be pulled out and rewound
after the belt has been fully rewound.
61–17