Table of Contents
Advertisement
WINDOW GLASS (ANTENNA WIRE)
REPAIR
Tester Probe
Tin Foil
Repair Point
Masking Tape
Repair Point
Glass
AVENSIS REPAIR MANUAL (RM1018E)
AUDIO & VISUAL SYSTEM
1.
INSPECT WINDOW GLASS (ANTENNA WIRE)
NOTICE:
When cleaning the glass, wipe it in the direction of the wire
with a soft and dry cloth. Take care not to damage the wire.
Do not use detergents or glass cleaners with abrasive in-
Heat Wire
gredients. When measuring voltage, wind a piece of tin foil
around the tip of the tester probe and press the foil against
the wire with your finger, as shown in the illustration.
BE4029
(a)
Check the continuity, at the center of each antenna wire,
as shown in the illustration.
E32576
2.
REPAIR WINDOW GLASS (ANTENNA WIRE)
(a)
Clean the broken wire tips with a grease, wax and silicone
remover.
(b)
Place the masking tape along both sides of the wire to be
repaired.
(c)
Thoroughly mix the repair agent (Dupont paste No.4817).
Broken
Wire
BE0150
(d)
Using a fine tip brush, apply a small amount of the mixture
to the wire.
Fine Tip Brush
(e)
After a few minutes, remove the masking tape.
(f)
Do not repair the defogger wire for at least 24 hours after-
wards.
BE0151
http://vnx.su
–
WINDOW GLASS (ANTENNA WIRE)
67–33
670SL–01
Advertisement
Table of Contents
