Toyota Avensis ZZT251 2003 Service And Repair Manual page 1012

+
–
1
2
AVENSIS REPAIR MANUAL (RM1018E)
FRONT SUSPENSION – FRONT WHEEL ALIGNMENT
(e) Adjust the camber by pushing or pulling the lower side of
the shock absorber in the direction in which the camber
adjustment is required.
(f) Tighten the nuts.
Torque: 220 N m (2,240 kgf cm, 162 ft lbf)
(g) Install the front wheel.
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
(h) Check the camber.
F44962
HINT:
Y
Adjust the camber to the center of the specified value as
much as possible.
Y
Adjusting value for the set bolts is 6' – 30' (0.1° – 0.5°).
If the camber is not within the specified value, using the follow-
ing table, estimate how much additional camber adjustment will
be required, and select the camber adjusting bolt.
NOTICE:
Tighten the adjusting bolt with a washer and a new nut.
F13685
Bolt
Adjusting
Value
–1°30' – –1°15'
–1°15' – –1°00'
–1°00' – –45'
–45' – –30'
–30' – –15'
–15' – 0'
0' – 15'
15' – 30'
30' – 45'
45' – 1°00'
1°00' – 1°15'
1°15' – 1°30'
(i) Perform the procedure mentioned above again. At step
(b), replace 1 or 2 selected bolts.
HINT:
When replacing the 2 bolts, replace 1 bolt for each time.
http://vnx.su
Adjusting Bolt
Set Bolt
90105–17008 90105–17009 90105–17010 90105–1701 1
1 Dot
1 2 1 2
26–9
3 Dots
2 Dots
1 2 1 2
F12938