Table of Contents
Advertisement
17–6
LUBRICATION SYSTEM (1AZ–FE)
ON–VEHICLE INSPECTION
1.
CHECK ENGINE OIL LEVEL
(a)
After warm up the engine and then 5 minutes after the engine stop, oil level should be between the
low level and full level marks of the dipstick.
If low, check for leakage and add oil up to the full level mark.
NOTICE:
Do not fill with engine oil above the full level mark.
Recommended Viscosity (SAE)
20 W – 50
15 W – 40
10 W – 30
5 W – 30 PREFERRED
YC
–29
–18
–7
4
YF
–20
0
20
40
TEMPERATURE RANGE ANTICiPATED
BEFORE NEXT OIL CHANGE
Oil Pressure Switch
Oil Pressure Switch
Oil Pressure Gauge
Oil Pressure Gauge
5.
WARM UP ENGINE
AVENSIS REPAIR MANUAL (RM1018E)
LUBRICATION
2.
(a)
If the quality is visibly poor, replace the oil.
16
27
38
60
80
100
A56466
3.
(a)
(b)
B11410
4.
(a)
B11411
http://vnx.su
–
LUBRICATION SYSTEM (1AZ–FE)
CHECK ENGINE OIL QUALITY
Check the oil for deterioration, entry of water, discoloring
or thinning.
Oil grade:
API grade "SJ" Energy–Conserving, "SL" Energy–
Conserving or ILSAC multi grade engine oil. Recom-
mended viscosity is as shown in the illustration.
REMOVE OIL PRESSURE SWITCH ASSY
Disconnect the oil pressure switch connector.
Using a deep socket wrench 24mm, remove the oil pres-
sure switch.
INSTALL OIL PRESSURE GAUGE
Install the oil pressure gauge.
1700F–09
Advertisement
Table of Contents
