Toyota Avensis ZZT251 2003 Service And Repair Manual page 1351

NOTICE:
Y
When checking the compressor oil level, observe the precautions on the cooler removal/instal-
lation.
Y
Since compressor oil remains in the pipes of the vehicle, if a new w/pulley compressor assy
is installed without removing some oil inside, the oil amount becomes excessive, preventing
heat exchange in the refrigerant cycle and causing refrigerant failure.
Y
If the remaining oil in the removed w/pulley compressor assy is too small in volume, check for
oil leakage.
Y
Be sure to use ND–OIL 8 for compressor oil.
(1)
(4)
(3)
(2)
11. INSTALL FAN AND GENERATOR V BELT
SST 09249–63010
AVENSIS REPAIR MANUAL (RM1018E)
HEATER & AIR CONDITIONER
10. INSTALL W/PULLEY COMPRESSOR ASSY
(a) Install the w/pulley compressor assy with the 4 bolts.
Torque: 29 N m (300 kgf cm, 21 ft lbf)
NOTICE:
Tighten the bolts in the order shown in the illustration to
install the w/pulley compressor assy.
(b) Connect the connector.
I35328
(See page
12. INSTALL COOLER REFRIGERANT DISCHARGE
HOSE NO.1
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
(c) Install the O–ring on the cooler refrigerant discharge hose
No.1.
(d) Install the cooler refrigerant discharge hose No.1 on the
w/pulley compressor assy with the bolt.
Torque: 9.8 N m (100 kgf cm, 87 in. lbf)
13. INSTALL COOLER REFRIGERANT SUCTION HOSE
NO.1
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O–ring and the
I35327
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
(c) Install the O–ring on the cooler refrigerant suction hose
No.1.
http://vnx.su
– W/PULLEY COMPRESSOR ASSY (1AZ–FE)
14–105)
55–83