Toyota Avensis ZZT251 2003 Service And Repair Manual page 1537

66–8
Rain Sensor Adjust Switch
A
B
C
AVENSIS REPAIR MANUAL (RM1018E)
WIPER & WASHER
Rear Washer Switch (w/ Rear Wiper)
Switch position
ON (Rear wiper switch
OFF position side)
ON (Rear wiper switch
ON position side)
(b)
D
E67353
3.
(a)
(b)
E34081
(c)
http://vnx.su
– WIPER AND WASHER SYSTEM
Tester condition
OFF
2 (EW) – 3 (WR)
2 (EW) – 3 (WR),
2 (EW) – 10 (+1R)
Rain Sensor Adjust Switch Operation Check
(1) Check resistance between terminal of the terminal
12 (VR1) and the terminal 14 (VR2) when rain sen-
sor adjust switch is operated.
Switch position
A position
B position
C position
D position
WINDSHIELD WIPER MOTOR ASSY (LHD STEERING
POSITION TYPE)
LO Operation Check
(1) Connect the battery (+) to the terminal 1 (+1) of the
connector and the battery (–) to the terminal 5 (E)
of the connector, and check that the motor operates
with low speed (LO).
HI Operation Check
(1) Connect the battery (+) to the terminal 4 (+2) of the
connector and the battery (–) to the terminal 5 (E)
of the connector, and check that the motor operates
with high speed (HI).
Automatic Stop Operation Check
(1) Connect the battery (+) to the terminal 1 (+1) of the
connector and the battery (–) to the terminal 5 (E)
of the connector. With the motor being rotated at low
speed (LO), disconnect the terminal 1 (+1) to stop
the wiper motor operation at any position except the
automatic stop position.
(2) Using SST, connect the terminal 1 (+1) and the ter-
minal 3 (S), and the battery (+) to the terminal 2 (B)
to restart the motor operation at low speed.
SST 09843–18040
Specified condition
– No continuity
Continuity
Continuity
Resistance (f)
8
432 to 528
216 to 264
0