Table of Contents
Advertisement
60–22
SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
L
M
AVENSIS REPAIR MANUAL (RM1018E)
CAUTION:
Y
When removing the horn button assy, work must be
started 90 seconds after the ignition switch is turned
to the "LOCK" position and the negative (–) terminal
cable is disconnected from the battery.
Y
When storing the horn button assy, keep the upper
surface of the airbag deployment side facing upward.
(c)
Using a service–purpose wire harness for the vehicle, tie
down the horn button assy to the disc wheel.
Wire Harness
Wire harness: Stripped wire harness section
Diameter
1.25 mm
CAUTION:
If a wire harness which is too thin or an alternative object
is used to tie down the horn button assy, it may be snapped
by the shock when the airbag is deployed. This is highly
dangerous. Always use a wire harness for vehicle use
H40008
which has a diameter of at least 1.25 mm
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 x (Diameter)
(1)
Bolt:
L: 35.0 mm (1.378 in.)
M: 6.0 mm (0.236 in.)
Pitch: 1.0 mm (0.039 in.)
NOTICE:
Y
Tighten the bolts by hand until the bolts become diffi-
cult to turn.
H42627
Y
Do not tighten the bolts too much.
(2)
SST(s)
SST
H42628
http://vnx.su
–
HORN BUTTON ASSY
2
or more (0.0019 in
Install the 2 bolts with washers in the 2 bolts holes
of the horn button assy.
After connecting the SST(s) below to each other,
connect them to the horn button assy.
09082–00802 (09082–10801, 09082–30801)
2
. or more)
2
2
(0.0019 in
).
2
divided by 4
Advertisement
Table of Contents
