19–22
STARTING SYSTEM (1CD–FTV)
INSPECTION
Terminal C
Disconnect
AVENSIS REPAIR MANUAL (RM1018E)
STARTING & CHARGING
1.
NOTICE:
Terminal 50
These tests must be performed within 3 to 5 seconds to
avoid burning out the coil.
(a)
A78633
If the clutch pinion gear is not extended, replace the magnetic
switch.
(b)
If the clutch pinion gear returns, replace the magnetic switch.
Disconnect
A78634
(c)
If the clutch pinion gear does not return, replace the magnetic
switch.
A78635
http://vnx.su
–
STARTING SYSTEM (1CD–FTV)
INSPECT STARTER ASSY
Do pull–in test
(1)
Disconnect the field coil lead wire from terminal C.
(2)
Connect the battery to the magnetic switch as
shown in the illustration on the left. Check that the
clutch pinion gear is extended.
Do hold–in test
(1)
Disconnect the negative (–) lead from the terminal
C with the above condition (a) is being maintained.
Check that the pinion gear remains extended.
Inspect clutch pinion gear return
(1)
Disconnect the negative (–) lead from the switch
body. Check that the clutch pinion gear returns.
190NL–01