Toyota Avensis ZZT251 2003 Service And Repair Manual page 1245

Normal
5 mm (0.20 in.)
or less
Engine Idling
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
(c)
(d)
(e)
Abnormal
If there is foaming or emulsification, bleed the power steering
system.
R11229
(f)
(g)
(h)
If a problem is found, bleed power steering system.
(i)
Engine Stopped
4.
R11786
(a)
(b)
(c)
NOTICE:
Check that the valve of SST(s) is in the open position.
(d)
NOTICE:
Check that the valve of SST(s) is in the open position.
(e)
(f)
(g)
http://vnx.su
– POWER STEERING SYSTEM
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to
boost fluid temperature.
Fluid temperature: 80°C (176°F)
Check for foaming or emulsification.
With the engine idling, measure the fluid level in the oil
reservoir.
Stop the engine.
Wait a few minutes and remeasure the fluid level in the oil
reservoir.
Maximum fluid level rise: 5 mm (0.20 in.)
Check the fluid level.
CHECK STEERING FLUID PRESSURE
AZ Series:
Disconnect the pressure feed tube assy from the vane
pump assy (See page 51–9).
1CD–FTV:
Disconnect the pressure feed tube assy from the vane
pump assy (See page 51–19).
AZ Series:
Connect SST(s), as shown in the illustration on the next
page.
SST 09640–10010 (09641–01010, 09641–01030,
09641–01060)
1CD–FTV:
Connect SST(s), as shown in the illustration on the next
page.
SST 09640–10010 (09641–01010, 09641–01020,
09641–01030)
Bleed the power steering system.
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to
boost fluid temperature.
Fluid temperature: 80 °C (176 °F)
51–5